R&S LCX Series - System:communicate:lan:address; System:communicate:lan:apply; System:communicate:lan:dgateway; System:communicate:lan:dhcp

Remote control commands
R&S
®
LCX Series
217User Manual 1179.2260.02 ─ 02
Manual operation: See "Error Beep" on page 126
SYSTem:COMMunicate:LAN:ADDRess <Ip address>
Sets the IP address.
Parameters:
<Ip address> Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Network communication settings" on page 214.
Manual operation: See "IP Address" on page 152
SYSTem:COMMunicate:LAN:APPLy
Assigns and confirms the settings.
Example:
See Example "Network communication settings" on page 214.
Usage: Event
SYSTem:COMMunicate:LAN:DGATeway <Gateway>
Sets the IP address of the default gateway.
Parameters:
<Gateway> Range: 0.0.0.0. to ff.ff.ff.ff
Example: See Example "Network communication settings" on page 214.
Manual operation: See "Gateway" on page 153
SYSTem:COMMunicate:LAN:DHCP <En-/Disable DHCP>
Parameters:
<En-/Disable DHCP> ON | OFF | 1 | 0
*RST: OFF | 0
Example: See Example "Network communication settings" on page 214.
Manual operation: See "DCHP & Auto-IP" on page 152
SYSTem:COMMunicate:LAN:DISCard
Removes the LAN configuration.
Usage:
Event
SYSTem:COMMunicate:LAN:EDITed?
Usage:
Query only
SYSTem subsystem