R&S LCX Series - Using the SaveRecall Function

General instrument settings
R&S
®
LCX Series
134User Manual 1179.2260.02 ─ 02
Recall Settings from file...
Reloads a previously saved instrument configuration.
Default Settings
Sets all parameters except for system settings to default.
Factory Reset
Resets the instrument to the initial factory settings.
9.12.2 Using the save/recall function
You can save the current instrument settings to a file, and load these settings in one
step again, e.g. to repeat tests with the same settings.
Saving instrument settings
To save the current instrument settings in a file:
1. Press the [settings] key at the front panel.
2. In the "Device" tab, select "Save/Recall Device Settings".
3. Select "Save Settings to File...".
If you have connected an external USB memory device, the R&S LCX opens a
selection editor.
a) Select the memory location, you want to save the settings file.
b) Confirm your selection.
The R&S LCX opens a file selection dialog where you can choose an existing file,
or create a file.
Note: With no USB connected, the instrument leads you to the internal settings
directory directly.
4. To select an existing file:
a) In the file directory window, select the file.
b) Confirm with "Save".
5. To create a settings file:
a) Select the file name entry field.
b) In the on-screen keyboard, enter the file name.
c)
When completed, confirm your entry
.
The R&S LCX saves the current instrument settings.
Recalling instrument settings
To load a settings configuration from a file, proceed the same way:
1. Select [settings] > "Device" > "Save/Recall Device Settings".
2. Select "Recall Settings to File...".
Save/recall