R&S LCX Series - Interfaces:usb:class

Remote control commands
R&S
®
LCX Series
215User Manual 1179.2260.02 ─ 02
*************************************************
// Set the USB interface protocol:
INTerfaces:USB:CLASs "TMC"
INTerfaces:USB:CLASs.................................................................................................. 215
SYSTem:BEEPer:WARNing:STATe.................................................................................. 216
SYSTem:BEEPer:WARNing[:IMMediate].......................................................................... 216
SYSTem:BEEPer[:COMPlete]:STATe............................................................................... 216
SYSTem:BEEPer[:COMPlete][:IMMediate]........................................................................216
SYSTem:COMMunicate:LAN:ADDRess............................................................................217
SYSTem:COMMunicate:LAN:APPLy................................................................................ 217
SYSTem:COMMunicate:LAN:DGATeway..........................................................................217
SYSTem:COMMunicate:LAN:DHCP.................................................................................217
SYSTem:COMMunicate:LAN:DISCard..............................................................................217
SYSTem:COMMunicate:LAN:EDITed?..............................................................................217
SYSTem:COMMunicate:LAN:HOSTname.........................................................................218
SYSTem:COMMunicate:LAN:MAC?.................................................................................218
SYSTem:COMMunicate:LAN:RESet.................................................................................218
SYSTem:COMMunicate:LAN:SMASk............................................................................... 218
SYSTem:COMMunicate:NETWork:VNC:PORT..................................................................218
SYSTem:COMMunicate:NETWork:VNC[:STATe]............................................................... 219
SYSTem:COMMunicate:NETWork:VNC:PORT..................................................................219
SYSTem:COMMunicate:NETWork:VNC[:STATe]............................................................... 219
SYSTem:DATE.............................................................................................................. 219
SYSTem:HW:VERSion?..................................................................................................220
SYSTem:KEY:BRIGhtness.............................................................................................. 220
SYSTem:LOCal..............................................................................................................220
SYSTem:REMote........................................................................................................... 220
SYSTem:RESTart...........................................................................................................220
SYSTem:RWLock...........................................................................................................221
SYSTem:SETTing:DEFault:SAVE.................................................................................... 221
SYSTem:TIME...............................................................................................................221
SYSTem:UPTime?......................................................................................................... 221
INTerfaces:USB:CLASs <USB class>
Selects the USB communication class.
Parameters:
<USB class> CDC | TMC
CDC
Uses the virtual communication port protocol, that enables you
to emulate serial ports over USB.
TMC
Uses the protocol for communication with USB devices.
Example: See Example "Network communication settings" on page 214.
Manual operation: See "USB Class" on page 156
SYSTem subsystem