R&S LCX Series - System:communicate:lan:hostname; System:communicate:lan:mac; System:communicate:lan:reset; System:communicate:lan:smask

Remote control commands
R&S
®
LCX Series
218User Manual 1179.2260.02 ─ 02
SYSTem:COMMunicate:LAN:HOSTname <Device hostname>
Sets an individual hostname for the R&S LCX.
Parameters:
<Device hostname>
Example: See Example "Network communication settings" on page 214.
Manual operation: See "Desired Hostname" on page 151
SYSTem:COMMunicate:LAN:MAC?
Queries the MAC address of the network.
Example:
See Example "Network communication settings" on page 214.
Usage: Query only
Manual operation: See "MAC Address" on page 153
SYSTem:COMMunicate:LAN:RESet
Terminates the network configuration and restarts the network.
Example:
See Example "Network communication settings" on page 214.
Usage: Event
Manual operation: See "Reset LAN Conection" on page 153
SYSTem:COMMunicate:LAN:SMASk <Subnet mask>
Sets the subnet mask.
Parameters:
<Subnet mask>
Example: See Example "Network communication settings" on page 214.
Manual operation: See "Subnet Mask" on page 153
SYSTem:COMMunicate:NETWork:VNC:PORT <Port>
Sets the VNC port address.
Parameters:
<Port> Range: 100 to 65535
*RST: n.a. (factory preset: 5900)
Example: See Example "Network communication settings" on page 214.
Manual operation: See "VNC Port" on page 154
SYSTem subsystem