R&S LCX Series - Measurement Commands

Remote control commands
R&S
®
LCX Series
204User Manual 1179.2260.02 ─ 02
LOG:STIMe <Year>, <Month>, <Day>, <Hour>, <Minute>, <Second>
Sets the logging start time.
Setting parameters:
<Year> integer
Four-digit number, including the century and millennium informa-
tion.
<Month> Range: 1 to 12
<Day> Range: 1 to 365
<Hour> Range: 0 to 23
Default unit: h
<Minute> Range: 0 to 59
Default unit: min
<Second> Range: 0 to 59
Default unit: s
Example: See Example "Logging data settings" on page 201.
Manual operation: See "Start Time" on page 97
See "Set Date & Time" on page 97
LOG[:STATe] <Logging State>
Activates the data logging function.
Parameters:
<Logging State> ON | OFF | 1 | 0
*RST: OFF | 0
Example: See Example "Logging data settings" on page 201.
Manual operation: See "Enabled" on page 95
11.13 Measurement commands
This section describes the remote control commands to set the measurement mode,
query the main parameters and accuracy, and to get the results of a measurement.
It comprises commands of the following subsystems:
●
MEASure commands for setting the measurement parameters
●
INITiate command for starting a new measurement
●
READ commands for requesting measurement results
●
FETCh commands for validating the measurement results
Measurement commands