EasyManua.ls Logo

R&S LCX Series - Test Signal Commands

R&S LCX Series
242 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Remote control commands
R&S
®
LCX Series
175User Manual 1179.2260.02 ─ 02
*TRG
Trigger
Triggers all actions waiting for a trigger event. In particular, *TRG generates a manual
trigger signal. This common command complements the commands of the TRIGger
subsystem.
Usage: Event
Manual operation: See "Trigger source" on page 68
See "[Trig.]" on page 73
*WAI
Wait to continue
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC).
Usage:
Event
11.4 Test signal commands
The following section describes the commands for setting the test signal and general
measurement parameters.
Test signal commands

Table of Contents

Other manuals for R&S LCX Series

Related product manuals