R&S LCX Series User Manual

Instrument functions
R&S
®
LCX Series
100User Manual 1179.2260.02 ─ 02
Enabled.......................................................................................................................100
Sweep Parameter....................................................................................................... 100
Minimum......................................................................................................................100
Maximum.....................................................................................................................100
Interval Type................................................................................................................100
Step Size.....................................................................................................................101
Number of Points........................................................................................................ 101
Abort............................................................................................................................101
Enabled
Starts the dynamic impedance measurement process.
The R&S LCX displays a progress dialog until the measurement is complete, see
"Measuring in dynamic impedance measurement mode" on page 101.
Remote command:
DIMeasure:EXECute on page 190
Sweep Parameter
Opens a selection editor to determine the measurement signal parameter that changes
during the entire measurement process.
The R&S LCX varies this parameter within the range between Minimum and Maximum
in constant steps continuously. You can define the step width with the Interval type and
the corresponding settings parameter, either Step Size or "Number of Points"
on page 101.
"Test Signal Voltage"
Varies the test signal voltage level during the measurement process.
"Frequency"
Varies the frequency of the test signal.
"Voltage Bias"
Varies the voltage bias value.
"Current Bias"
Varies the voltage bias value.
Remote command:
DIMeasure:SWEep:PARameter on page 192
Minimum
Sets the first value of the range used for the selected sweep parameter.
Remote command:
DIMeasure:SWEep:MINimum on page 191
Maximum
Sets the last value of the range used for the selected sweep parameter.
Remote command:
DIMeasure:SWEep:MAXimum on page 191
Interval Type
Opens a selection editor to select the mode how the instrument calculates the width or
time between the recorded sweep parameters within the measurement range (Min/
Max).
Specific instrument functions

R&S LCX Series Specifications

General

Brand	R&S
Model	LCX Series
Category	Measuring Instruments
Language	English