R&S LCX Series User Manual

Instrument functions
R&S
®
LCX Series
101User Manual 1179.2260.02 ─ 02
"Step Size"
Uses the interval between one sweep parameter value to the next,
set with Step Size.
"Number of Points"
Uses the number of values within the range of minimum and maxi-
mum sweep parameter settings, set with Number of Points.
Remote command:
DIMeasure:INTerval:TYPE on page 191
Step Size
Sets the interval between each sweep step within the measurement range Min/Max).
Depending on the selected sweep parameter, the R&S LCX provides the correspond-
ing value and unit.
"xx V"
For Sweep Parameter > Test Signal Voltage or Voltage Bias, sets the
step width in V.
"xx Hz"
For Sweep Parameter > Frequency, sets the time interval in Hz.
"xx A"
For Sweep Parameter > Current Bias, sets the step width in A.
Remote command:
DIMeasure:INTerval:STEPsize on page 190
Number of Points
Sets the number of measurement points within the measurement range (Min/Max).
Remote command:
DIMeasure:INTerval:POINts on page 190
Abort
Cancels a dynamic impedance measurement process while it is running.
Remote command:
DIMeasure:ABORt on page 190
8.8.4.2 Using the dynamic impedance measurement function
The dynamic impedance measurement function records the measurement readings
automatically. The R&S LCX stores the data in a log file with a generically created file-
name, either on the USB stick or in the instrument internal memory directory.
Selecting the memory location
To determine the destination for saving the data file:
► Follow the steps described in "Selecting the memory location" on page 97.
Measuring in dynamic impedance measurement mode
1. Press the [settings] key at the front panel.
2. In the "Functions" tab, select "Dynamic Impedance Measurement".
3. Configure the required settings.
Specific instrument functions

R&S LCX Series Specifications

General

Brand	R&S
Model	LCX Series
Category	Measuring Instruments
Language	English