Remote Control - Commands
R&S
®
NRP2
315User Manual 1173.9157.02 ─ 03
●
IEC/IEEE-bus address
● resetting the R&S NRP2
●
setting the date and time
●
audible signals
●
version numbers of hardware and software
●
setting the system speed
SYSTem:BEEPer[:IMMediate].........................................................................................315
SYSTem:BEEPer:NOTify:OVERload................................................................................316
SYSTem:BEEPer:NOTify:KEY.........................................................................................316
SYSTem:BEEPer:STOP.................................................................................................316
SYSTem:BEEPer:TIME..................................................................................................316
SYSTem:COMMunicate:GPIB[:SELF]:ADDRess...............................................................316
SYSTem:COMMunicate:INET:MODE...............................................................................317
SYSTem:COMMunicate:INET[:SELF]:ADDRess...............................................................317
SYSTem:COMMunicate:INET[:SELF]:GATEway:ADDRess................................................317
SYSTem:COMMunicate:INET[:SELF]:SUBNetmask:ADDRess...........................................318
SYSTem:DATE..............................................................................................................318
SYSTem:IDN.................................................................................................................318
SYSTem:IDN:AUTO.......................................................................................................318
SYSTem:INFO?.............................................................................................................318
SYSTem:ERRor?...........................................................................................................319
SYSTem:ERRor:EXTended[:STATe]................................................................................320
SYSTem:KEY................................................................................................................320
SYSTem:LANGuage......................................................................................................321
SYSTem:OPT................................................................................................................321
SYSTem:OPT:AUTO......................................................................................................321
SYSTem:PRESet...........................................................................................................321
SYSTem:REBoot...........................................................................................................322
SYSTem:SENSor<[1]..4>:INFO?.....................................................................................322
SYSTem:SENSor<[1]..4>:REBoot....................................................................................322
SYSTem:SENSor<[1]..4>:RESet.....................................................................................322
SYSTem:SENSor<[1]..4>:TEST?.....................................................................................322
SYSTem:SPEed............................................................................................................322
SYSTem:STANdard:CATalog?........................................................................................323
SYSTem:STANdard:PRESet...........................................................................................323
SYSTem:STANdard:PWSettings.....................................................................................323
SYSTem:STANdard:TRIGger:SOURce............................................................................323
SYSTem:TIME...............................................................................................................324
SYSTem:VERSion?.......................................................................................................324
SYSTem:BEEPer[:IMMediate]
Generates an audible signal via the built-in loudspeaker. The duration of the signal is set
with SYST:BEEP:TIME. Frequency and volume cannot be changed. The signal is only
output if it is not switched off with SYS:BEEP:STAT OFF.
Usage:
Event
SYSTem