Reference Manual Rev 1.13
004R-646-113 Page 21
4.6. Selections and Options
A selection entry requires the choice of a single option from a list.
Using the up and down arrows, select the desired option and press the OK key.
Example: When in Setup follow the steps below to set Scale:Build:Cable.
Press <ZERO> repeatedly to display the SCALE menu.
Press <TARE> repeatedly to display the BUILD menu.
Press <GROSS/NET> repeatedly to display the CABLE item and the current
setting (eg. 4 WIRE).
Use the ↑ and ↓ keys to select the desired option from the list.
Press <OK>
4.7. Strings
There are 3 different methods of editing strings:
Normal string editing (auxiliary display: STR)
Numerical string editing (auxiliary display: S.NUM)
ASCII string with character position (auxiliary display: S.ASC)
Use the <+/-> key to cycle between these options.
4.7.1. Normal String Editing
Normal string editing is most useful where strings are small and contain no
lowercase or unprintable characters. The available characters are printed in orange
on the keypad.
Special keys are:
<OK>: Accept changes and finish.
<Long press of cancel>: Cancel and exit without changes
<Cancel>: Delete character
<Up>, <Down>: Move cursor
<Long press of down>: Delete string after cursor
<+/->: Switch editing modes
To Next Page
Loading...
