Rinstrum R427 - Ser.net

Reference Manual Rev 1.13
Page 72 004R-646-113
12.5. SER.NET
Path Description
└ SER.NET
└ ADDR
└ NUM
└ STRT.CH
└ END.CH.1
└ END.CH.2
└ NET.n
└ TYPE
└ SERIAL
└ RESP
└ SOURCE
Configure the serial networking support.
ADDR (Address): Address of instrument (1..31).
NUM: sets the number of networks
STRT.CH (start character): Character for lua buffer
to indicate start of new message.
END.CH.1 (end character): Character for lua buffer
to indicate end of new message.
END.CH.2 (end character): Character for lua buffer
to indicate end of new message.
TYPE: Type of Network Protocol:
 NONE: Disable networking
 RINCMD: See Network Communications
page 91.
 SIMPLE: See Network Communications page
91.
 BARCODE (K404 and K405 only): Use a
barcode reader for truck selection.
 LUA BUFFER (K422 only): Buffer all comms
for Lua module to read.
SERIAL: Serial Port to use.
RESP: Respond to simple protocol commands with
OK.
SOURCE: Barcode protocol source, settable to
product name (NAME), product barcode (B.CODE)
or product ID (ID).
ADDR Values <NUM>
1..31
NUM Values <OPT>
-1-
(Default)
.. -2-
TYPE Values <OPT>
NONE, RINCMD
(Default)
,
SIMPLE, BARCODE, LUA
BUFFER
SERIAL Values <OPT>
SER1A
(Default)
, SER2A,
SER3A
RESP Values <OPT>
NONE
(Default)
, OK
SOURCE Values <OPT>
NAME
(Default)
, B.CODE, ID