Rinstrum R427 - SPACE (Print Blank Space Options); Print.n

Reference Manual Rev 1.13
004R-646-113 Page 75
12.7.5. SPACE (Print blank space options)
Path Description
PRINT
└ SPACE
└ TOP
└ LEFT
└ BOTTOM
└ W.OUT
Space controls the amount of white space to leave
around the printout.
TOP: Sets the number of blank lines to add at the
top of each page.
LEFT: Sets the number of spaces to add at the
beginning of each line.
BOTTOM: Sets the number of blank lines to add to
the bottom of each page.
W.OUT: If this is not 0 then the header will not be
printed in weigh out mode, instead the set number
of lines will be skipped.
Values <NUM>
0 .. 10 Default: 0
W.OUT Values <NUM>
0 .. 50
Default: 0
12.7.6. PRINT.n … (Printout options)
Path Description
PRINT
└ PRINT.n
└ TYPE
└ FORMAT
└ SERIAL
└ NAME
└ CUSTOM
(*)
└ PRN.KEY
└ EV.D.NEW
└ EV.D.END
└ EV.WI
└ EV.WO.1
└ EV.WO.2
└ EV.D.WO
└ EV.AXLE
└ ABORT
└ EV.GRP
or
└ REP.ST
└ REP.PR
└ REP.END
Each printout has its own format settings.
TYPE: Sets the printout type. Options are:
 NONE (default)
 DOCKET
 REPORT
FORMAT: Sets the printout format.
SERIAL: Select Serial port to use.
NAME (Printout Name): Report printouts are
available by name to the operator.
CUSTOM: For custom printing, each type of printout
uses event strings as follows:
DOCKET:
PRN.KEY (K404 only)(Docket Print) controls the
format of each transaction on the docket.
EV.D.NEW (Event Docket New) defines the start
of the docket.
EV.D.END (Event Docket End) defines the end
of the docket (Normal mode only).
EV.WI (Event Weigh In) defines what is printed
when weighing in.
EV.WO.1 (Event Weigh Out 1) defines what is
printed when weighing out with Preset Tare.
EV.WO.2 (Event Weigh Out 2) defines what is
printed when weighing out with first weight.
EV.D.WO (Event Docket Weigh Out) defines the
end of docket when weighing out.
EV.AXLE (K405 and K422 only) defines the
string to be printed for each axle.
ABORT (K405 and K422 only) defines the string
to be printed if weighing aborted.
TYPE Values <OPT>
 NONE
(Default)
 DOCKET
 REPORT
FORMAT Values <OPT>
FMT.A
(Default)
, FMT.B
CUSTOM
SERIAL Values <OPT>
SER1A
(Default)
, SER2A,
SER3A