Reference Manual Rev 1.13
Page 54 004R-646-113
11.6.1. Full Setup Passcode
Setting a passcode for Full Setup restricts access to Full Setup.
11.6.2. Safe Setup Passcode
Setting a passcode for Safe Setup restricts access to Safe Setup functions. In
addition, front panel functions can be configured to prompt for a Safe Setup
passcode before operating. Refer to 12.1.4 KEY.LOC (Key Function Access
Control) on page 56 for more information.
11.6.3. Operator Passcode
The operator passcode is used to protect access to instrument functions available
from the front panel keypad. Refer to 12.1.4 KEY.LOC (Key Function Access
Control) on page 56 for more information on how to add security to operator
functions.
The operator generally needs to enter the Operator Passcode only once to gain
access to multiple functions. To lock the instrument again press the ‘.’ key for two
seconds (LOCK function).
11.6.4. Setup Lock-Out
If an attempt is made to enter Full or Safe Setup using an incorrect passcode, the
instrument will respond with the message ENTRY DENIED and then the user will be
returned to normal operating mode.
No more than three failed attempts can made to access Full/Safe Setup before the
instrument blocks access completely. The instrument must be turned off and on
again before further attempts can be made.
To Next Page
Loading...
