Reference Manual Rev 1.13
Page 62 004R-646-113
12.2.5. IO.HW
Path Description
H.WARE
└ IO.HW
└ FRC.OUT
└ TST.IN
└ DB.1.8
└ DBNC.1
:
└ DBNC.8
└ DB.9.16
└ DBNC.9
:
└ DBNC.16
└ DB.17.24
└ DBNC.17
:
└ DBNC.24
└ DB.25.32
└ DBNC.25
:
└ DBNC.32
FRC.OUT (Force Outputs)
Use this when testing and fault finding to force the
IO on and off. Use the UP and DOWN keys to
select the output. Use the +/- key to switch the
output on and off.
TST.IN (Test Inputs)
Use this when testing and fault finding to check
the status of IO when used as inputs. Inputs are
listed for each module in order of lowest to highest
IO number. ‘1’ means the input is active, ‘0’
means the input is inactive. Use the UP and
DOWN keys to select the module to view.
DBNC (Debounce)
This sets the amount of debouncing for inputs. It
is set in milliseconds [ms].
DBNC Values <NUM>
1..250 ms
Default: 50 ms
12.2.6. DSD.HW
Path Description
H.WARE
└ DSD.HW
└ AUTO.C
└ DSD.STR
AUTO.C (Auto Clear)
Sets whether the DSD will automatically write over
the oldest records when it becomes full.
DSD.STR (DSD String)
Custom string to be stored along with the traceable
data when the DSD is written. This accepts all print
tokens.
AUTO.C Values <OPT>
OFF, ON
(Default)
DSD.STR Values <STR>
Maximum 20 characters.
To Next Page
Loading...
