Risco RW332M - Cloud

Page 106
Communication: Follow-Me
Parameter
Default
Range
Nor Applicable.
Follow Me Periodic Test
The Periodic Test enables you to set the time period that the system will
automatically establish communication to a Follow Me destination defined with
the Periodic Test event.
Cloud
Define here the server settings for communication with the WiComm Pro system
IP Address
91.221.51.215
The IP address or server name. If the WiComm Pro system is connected to the
RISCO Cloud for self-monitoring, then use: riscoCloud.com. Otherwise enter the
IP address or name where the Cloud server is located.
IP Port
33000
The server port address.
Password
AAAAAA
Up to 6 characters
(case sensitive)
Specify the password for server access. This password should be identical to the
CP Password defined in the server under the Control Panel page definition.
Channel
Communication with the Cloud can be established through an IP or GPRS
channel:.
• IP Only
• GSM Only
• IP/GPRS (Default)
• GPRS/IP
Controls
The WiComm Pro supports parallel channel reporting (via IP, GPRS or SMS) to
both the monitoring station and Follow Me when connected via the Cloud. Use
this setting to decide if the panel will report events to the monitoring station or
Follow-Me in parallel to the report to the Cloud, or only as a backup when the
communication between the WiComm Pro and the Cloud is not functioning.
Note: When the backup mode is functioning, the monitoring station
specifications are as defined under Monitoring Station (MS) menu and Follow-
Me menu.