The siren communication test performs a communication test between the WiComm Pro
and the selected siren. The value displayed indicates the siren's signal strength as
received by the WiComm Pro.
For successful communication, the strength of the signal should be higher than the noise
threshold level as measured during calibration of the main panel.
Speaker batteries voltage: Tests the selected siren’s speaker batteries voltage.
Radio (Transceiver) batteries voltage: Tests the selected siren’s radio's batteries voltage.
Activates squawk sound in the selected siren.
This establishes the threshold noise level of the wireless siren receiver. The threshold
noise level can be established automatically or manually (when using a keypad).
To establish a siren receiver's noise level:
1. Select the siren for which you want to calibrate its receiver.
2. For automatic calibration select [2] Calibration. After the calibration process is
accomplished, the new noise threshold level is displayed.
3. For manual calibration select [1] View/Edit. The value displayed is the last
measured value. Set a new threshold level and press to confirm.
This menu displays information regarding the siren's version.
To Next Page
Loading...
