Risco RW332M - Wireless Device Allocation Options

Page 22
3. Use the buttons to scroll between the following Programming menu items
(“sub-menus”):
• 1) System
• 2) Radio Devices
• 3) Codes
• 4) Communication
• 0) Exit
4. To exit the Programming sub-menus, press zero (0).
Wireless Device Allocation Options
All wireless devices (detectors and accessories) must also be allocated (“enrolled”) to the
system. This can be performed at:
• Main panel: Perform Quick Allocation of all devices by sending an RF signal
transmission from each device to the main panel (see procedure below).
• LCD keypad: The following methods are available:
For having devices assigned automatically (and sequentially): You can either
perform this by the “RF Allocation” method, or by entering each device’s
unique 11-digit code (serial number) into the system.
For manually selecting a specific device number to which a device is then
allocated: You can perform this by the “Zone Allocation” method.
• Configuration Software: Refer to the Configuration Software documentation for
details.