Risco RW332M - System Timer Settings

Page 32
Timers
The Timers option has the following parameters:
System: Timers
Parameter
Default
Range
Exit/Entry Delay 1
The amount of time before the system is armed/disarmed. Usually used on front entrance
door.
Entry Delay 1
45 sec
0-255 sec
Duration of entry delay 1 before the system is disarmed.
Exit Delay 1
45 sec
0-255 sec
Duration of Exit Delay 1 before the system is armed.
Exit/Entry Delay 2
The amount of time before the system is armed/disarmed. Usually used on back door.
Entry Delay 2
45 sec
0-255 sec
Duration of Entry Delay 2 before the system is disarmed.
Exit Delay 2
45 sec
0-255 sec
Duration of Exit Delay 2 before the system is armed.
Bell Timeout
03 min
01-90 min
Duration of the siren during an alarm.
Bell Delay
00 min
00-90 min
The time delay before a siren sounds after an alarm is triggered.
AC Off Delay
30 min
0-255 min
In the case of a loss of AC power, this parameter specifies the delay period before
reporting the event or operating the programmable output. If the delay time is set to zero,
there will be no delay period.
Jamming Time
30
None, 10, 20 or 30 sec
Specifies the period that the system's receiver tolerates unwanted radio frequencies
capable of blocking (jamming) signals produced by the system's transmitters. Once the
specified time is reached, the system sends a report code to the monitoring station or
activates a local siren, depending on the Audible Jamming system control.
NONE: No jamming will be detected or reported.
RX Supervision
2 hours
0-7 hours