Risco RW332M - Siren Configuration Parameters

Page 73
Sirens
Sirens enables defining all parameters of external and internal wireless sirens that can be
connected to the system. Up to 3 sirens can be added to the system.
For detailed information regarding the operation of the sirens refer to the instructions
supplied with the product.
Wireless Device: Sirens
Parameter
Default
Range
Label
A label identifying the siren.
Serial Code
The internal ID number of the sirens. Each wireless device has its own unique serial
number. Placing ID 00000000000 will delete the siren.
Partition
Assign the partitions that will effect the sounder operation.
Supervision
YES
Choose if the siren will be supervised or not.
Volume
9
0-9
Define the volume of the sounder for the following scenarios in the system.
Alarm Volume
9
0-9
The sound volume produced during an alarm (0 indicates silence).
Squawk Volume
9
0-9
The sound volume produced during squawk sounds (0 indicates silence).
Exit/Entry Volume
9
0-9
The sound volume produced during exit/entry time. (0 indicates silence).
Strobe (External siren only)
Defines the parameters for the strobe of the external siren.
Strobe Control
Defines the Strobe operation mode:
• Always off: The strobe is deactivated
• Follow Bell: The strobe is activated when the siren bell is triggered
• Follow Alarm: The strobe is activated when an alarm event occurs in the
system