Risco RW332M - I;O Wireless Expander; Wired Zones

Page 74
Wireless Device: Sirens
Parameter
Default
Range
Strobe Blink
40
Defines the number of times that the strobe will blink in a minute:
• 20 times per minute
• 30 times per minute
• 40 times per minute
• 50 times per minute
• 60 times per minute
Strobe Arm Blink
05
00-20
Defines the time that the strobe will blink when the system is armed.
I/O Wireless Expander
The Wireless I/O (Input/Output) Expander is a self-powered device enabling system
control of an additional 4 wired zones, with home automation capabilities. With the I/O
Expander, the system has 4 physical outputs that can control 16 home-automation devices
employing the X-10 protocol.
Wired Zones
The 4 inputs on the I/O Expander are regarded as zones 33-36 in the system.
I/O Expander: Wired Zones
Parameter
Default
Range
Label
A label identifies the zone in the system (up to 16 characters).
Partition
1
The partitions assignment for each zone.
Type
Intruder
Contains parameters that enable you to program the zone type for any zone. Refer to the
list of options for the Zone Type on page 50.
Sound
Bell
Not Applicable
Advanced programming
Chime
None
The Chime parameter is used as an audible beep indication to a zone violation while the
system is Disarmed.
Control
Forced Arm