Risco RW332M - Monitoring Station

Page 92

The communication with MS 1 is disconnected.
Default is 00003 (30 seconds)
Controls
Disable IP
NO
YES/NO
YES: The system will disable the IP from any activity.
NO: The IP is enabled in the system.
CS via IP YES YES/NO
YES: The system allows access to Configuration Software through an IP
connection
NO: The system does not allow access to Configuration Software through an IP
connection
Monitoring Station
The Monitoring Station option contains parameters that enable the system to establish
communication with the monitoring stations (up to three) and transmit data.
Communication: Monitoring Station
Parameter
Default
Range
Report Type
Type
Defines the communication type that the system will establish with each
monitoring station. The system can report in 3 optional communication types:
⬧ SMS
⬧ IP
⬧ SIA IP
SMS
Events are sent to the monitoring station using encrypted SMS
messages (128 BIT AES encryption). Each event message contains
information including the account number, report code,
communication format, time of event and more. The event messages
are received by RISCO Group's IP/GSM Receiver Software located at
the MS/ARC site. The IP/GSM Receiver translates the SMS messages to
standard protocols used by the monitoring station applications (For
example; Contact ID).This channel requires that RISCO Group’s
IP/GSM receiver has to be used at the MS side.
Enter the relevant phone numbers for the MS that will receive reports
from the system (see page 102).