Page 23
Quick Device Allocation at the Main Panel
You can quickly allocate all system devices at the main panel.
NOTE: For quick allocation at the main panel, the system bit Quick Learn must be
enabled.
➢ To quickly allocate all wireless devices at the main panel:
4. Make sure batteries are installed in each device.
5. At the main panel press the LEARN button for 5 seconds; all three LEDs light up, one
after the other, indicating the panel is in “Learn” (allocation) mode.
6. Send an RF signal transmission to the main panel from each device per the instructions
in the Table of Device Transmissions, page 24. If a device is not listed in the table, refer to
the device’s packaged instructions.
NOTE: For future use, it is recommended to write down for the customer the device
description, zone number, and installation location of each allocated device.
To Next Page
Loading...
