Communication: Monitoring Station
Enables you to view or program the codes transmitted by the system to report events (for
example, alarms, troubles, restores, supervisory tests, and so on) to the monitoring
station. The codes specified for each type of event transmission are a function of the
Monitoring Station's own policies. Before programming any codes, it is important to
check the Monitoring Station protocols. Reporting codes are assigned by default,
according to the selected communication format SIA or Contact ID
Assigns a specified report code for each event, based on the reporting format to the
monitoring station. An event that is not assigned with a report code will not be reported
to the monitoring station. For list of report events refer to Appendix A -- Report Codes.
Configuration Software
The Configuration Software option contains parameters that enable the configuration
software to establish connection with the system.
Communication: Configuration software
Enables you to set parameters for remote communication between the technician and the
system using the Configuration software
Enables you to define an access code that is stored in the system.
RISCO Group recommends using a different 4-digit access code for each
installation.
In order to enable communication between the alarm company and the system
the same access code must subsequently be entered into the corresponding
account profile created for the installation in the configuration software
For successful communication, the access code along with the ID code must
match between the configuration software and the system.
To Next Page
Loading...
