Risco RW332M - Remote Controls and Key Fobs Parameters

Page 68
Remote Controls / Key Fobs
Remote Controls / Key Fobs defines the operation of the remote controls / key fobs. Up to
8 remote controls / key fobs can be assigned to the system. The system supports 2 types:
• One-way (one-directional) key fobs (4-button model)
• Two-way (bi-directional) remote controls (8-button model)
The programming options under parameters vary according to the type of key fob or
remote control (Wireless 1-Way Key Fob, or Wireless 2-Way Remote Control)
Wireless One-Way Key Fob Parameters
Each Wireless 1-Way Key Fob consists of 4 buttons, and each button can be programmed to
a different mode of operation.
Remote Control Parameters – 1-Way Key Fob
Parameter
Label
A label identifying the user of the key fob.
Serial Code
The internal ID number of the key fob. Each wireless device has its own unique serial
number. Placing ID 00000000000 will delete the key fob.
Partition
Assign the relevant partitions for the selected key fob.
Button 1 ()
Set the operation of button 1 of the key fob from the following options:
• None: Button disabled
• Arm: The button is used for Away (Full) arming of the key fob‘s partitions
• Stay: The button is used for Stay (Partial) arming of the key fob’s partitions
Button 2 ()
Set the operation of button 2 of the key fob from the following options:
• None: Button disabled
• Disarm: The button is used for disarming its assigned partitions
Button 3
Set the operation of button 3 (small blank button) of the key fob from the following
options:
• None: Button disabled
• Panic: The button is used to send a panic alarm
• Status: Main panel broadcast of system status
• UO Control (1-20): The button is used to operate a single utility output