manner, while simultaneously transmitting the duress alarm. In any other situation the
Duress authority level behaves as the same as the User authority level.
Door Bypass: Use this authority level when the slim keypad reader is defined in Bypass
mode. The authorization code defined here initiates the Entry Bypass timer (see page 34).
This authority is recognized only on a wireless 2-way slim keypad (not an installer’s LCD
keypad).
Grand Master
The Grand Master code is used by the system's owner and is the highest authority level.
The owner can set/change the Grand Master code. Default is 1234
Note: In the Configuration Software the Grand Master is identified as Code 00.
Installer
The installer code provides access to the installer Programming menu, allowing
modification of all system parameters. The installer Code is used by the WiComm Pro
installation company technician to program the system. The installer can change the
installer code (default is 1111).
Guard
The Guard code allows limited operations on the system. The Guard has permission to
disarm the system after an alarm occurs in the system. The code will be valid only 2
minutes after alarm condition.
Default is 5678
Note: The Guard User Code is available only for some Customer IDs.
Code Length
Code Length specifies the minimum number of digits requested. Default is 4 digits.
Notes:
When you change the Code Length parameter, all User Codes are deleted and must be re-programmed or
downloaded.
For a 6-digit Code Length system, 4-digit default codes like 1-2-3-4 (Grand Master), 1-1-1-1 (Installer), and
5-6-7-8 (Guard) become 1-2-3-4-0-0, 1-1-1-1-0-0, and 5-6-7-8-0-0, respectively.
If you change the Code Length back to 4 digits, the system codes are restored to the default 4-digit codes.
EN50131-3 standard specifications:
⬧ All code length are 4 digits: xxxx
⬧ For each digit 0-9 can be used
⬧ All codes from 0000 to 9999 are acceptable
To Next Page
Loading...
