Risco RW332M - Define Follow Me

Page 102
Define Follow Me
Communication: Follow-Me
Parameter
Default
Range
Label (via the Configuration Software)
A label identifying the follow me destination
Report Type
Defines the type of reporting events to a Follow Me destination:
• Voice: Not Applicable.
• SMS: Report to Follow Me will be done by SMS. Each event message contains
information including the system label, Event type and time. Type in the telephone
number including area code or special letters for Follow Me destination.
• E-mail: Report to Follow Me will be done by e-mail thorough IP or GPRS. Each e-
mail contains information including the system label. Event type and time. (See
Channel > For E-mail report below).Enter the e-mail address for Follow Me
destination defined as e-mail type.
Channel
Email reporting events can be established through different channels. The optional
channels depend on the hardware installed in the system. Select the required channel as
follows:
• IP/GPRS: The system checks for the availability of the IP network. During regular
operation emails will be sent using the IP network line. In the case of trouble in the IP
network, the email is routed to the GPRS network.
• GPRS/IP: The system checks for the availability of the GPRS network. During regular
operation mode emails will be sent using the GPRS. In the case of trouble, the email is
routed to the IP network.
• IP Only: The report is executed through the IP network only
• GPRS Only: The report is executed through the GPRS network
Events
Each Follow Me destination can be assigned with its own set of events. Choose the events
that will be reported to each Follow Me
Event
Description
Default
Alarms
Intruder
Intruder alarm in the system
Yes
Fire
Fire alarm in the system
Yes
Emergency
Emergency alarm in the system
Yes
Panic (S.O.S)
A panic alarm in the system
Yes
Tamper
Any tamper alarm in the system
No