Communication: Configuration software
Define 3 numbers that the panel can call to perform Configuration Software
communication. If no numbers have been defined, a call back can be performed
to any phone. The installer will enter a phone number when establishing
communication to the panel. If at least one number has been defined, it will be
the only number that the call back can be established too.
When the Configuration Software establishes communication to the panel, it
sends the panel its calling phone number. (This number needs to be defined as
My Number under the GSM Communication menu in the Configuration
Software.)
If the panel identifies one of the numbers as one of the numbers predefined in
the panel, the call will hang up and the panel will call back to that same number.
Configuration Software Port (IP Gateway)
The IP and port address of the configuration's software PC. If you have a router
connected to the PC of the configuration software then you should enter the IP of the
router.
This definition will be used when there is a request to create a remote connection from
the panel to the configuration software. The connection can be done over IP or GPRS.
Note: In the configuration software, under Communication> Configuration>GPRS you should enter the IP
address of the PC that the software is installed in.
The IP address of the Configuration Software’s PC
The IP port of the Configuration Software’s PC
The GPRS Port to which the Configuration Software can connect when GSM is in Listener
mode.
The host subnet address (listener port number)
Follow-Me
In addition to reporting to the monitoring station, the WiComm Pro can notify end users of
various system events. Reporting can be done directly from the WiComm Pro to the end
user by SMS (up to 16). Reporting can also be by Email or Push Notification from the main
unit or using the RISCO Cloud. When using the Cloud, the number is unlimited
To Next Page
Loading...
