Page 16
Chapter 4: Installing the WiComm Pro
Installing the Main Panel
IMPORTANT:
Only alarm system installers or similar professionals (such as electricians) should
install and service the WiComm Pro
Mounting Guidelines
Install the main panel in consideration of the following guidelines:
• Install in a centrally-located place, between all the wireless devices in your
system, for optimal communication
• Install in a protected area, that is not visible from outside of the premises
• Make sure it is not reachable by small children
• Install in a place where the alarm can be heard during Partial Arm mode
• Make sure it is installed where the GSM signal is good, as indicated by the
communication LED lit up in green
• If an IP connection is used, install close to the router / wall IP connection
• Install near an uninterrupted 230V AC electrical outlet
Do not install the main panel as follows:
• Do not install near direct heat sources
• Avoid proximity to sources of electrical disturbance, such as computers and
televisions
• Do not install near large metal objects, as they may hinder antenna performance
Wall-Mounting the Main Panel
The main panel can be wall-mounted either horizontally or vertically.
NOTE: For an EN50131-compliant installation, the main panel must be mounted
horizontally (with LEDs facing upward)
To Next Page
Loading...
