Risco RW332M - Wireless Device RF Transmissions

Page 24
Wireless Device RF Transmissions
Wireless Device
Transmission procedure
2-Way LCD Keypad
Press and simultaneously for at least 2 seconds
2-Way Panda Keypad
Press and simultaneously for at least 2 seconds.
2-Way Slim Keypad
Press and simultaneously for at least 2 seconds.
PIR Detectors:
• PIR
• PIR camera
• PIR-pet
• PIR-pet camera
Press the tamper switch for 3 seconds.
Curtain Detector
After inserting battery, close the bracket and wait 3 seconds.
1-Way magnetic
Contact Detectors
Press the tamper switch for 3 seconds.
2-Way Magnetic
Contacts Detectors
Press the tamper switch for 3 seconds.
NOTE: After programming parameters for this device and
exiting Programming mode, press the Tamper switch for 3
seconds, and then wait 1 minute for the main panel to
download the parameters from the detector.
2-Way Remote
Control
Press and simultaneously for at least 2 seconds
1-Way Keyfob
Click  for at least 2 seconds
Wireless 2-Way
Smoke Alarm & Heat
Detector
Press the tamper switch for 3 seconds.
WL 2-Way Indoor
Siren
Press the tamper switch for 3 seconds.
Siren
Press the reset switch on the siren. After a squawk sounds,
within 10 seconds press tamper switch for at least 3 seconds.
2-Button Panic Keyfob
Press both buttons for at least 7 seconds
Wrist Band Panic
Transmitter
Press the button for at least 7 seconds.
When all the devices have been allocated, short-press the LEARN button to exit Learn
mode; the LEDs stop flashing