Risco RW332M - Appendix B: Installer Event Log Messages

Page 123
Appendix B: Installer Event Log Messages
* Event message display cannot be suppressed, as specified by EN50131-1-2006.
Event Message
Description
Activate UO=xx
UO XX activation
Actv UO=xx KF=zz
UO XX is activated from remote control ZZ
AL Reinstate P=y
Alarm reinstatement on partition Y
Alarm abort P=y
Alarm aborted on partition Y
* Alarm Zone=xx
Alarm in zone no. XX
* Anti-code reset
Remote reset
Auto Add GSM
GSM added to the main panel
Auto Add IP card
IP added to the main panel
Auto Add MODEM
Modem added to the main panel
Auto Del GSM
GSM was removed from the main panel
Auto Del IP card
IP removed from the main panel
Auto Del MODEM
Modem removed from the main panel
Auto test fail
Failure of zone self-test
Auto test OK
Automatic zone self-test OK
* Away fail P=y
Partition Y failed to arm
* Away:P=y C=zz
Partition Y armed by user no. ZZ
* Away:P=y KF=zz
Partition Y armed by remote control ZZ
* Bell tamper
Bell tamper alarm
Bell tamper rst
Bell tamper alarm restore
* Box tamper
Box tamper alarm from main panel
Box tamper rst
Box tamper alarm restore
* Bypass Box+Bell
Box + Bell tamper is bypassed
Bypass code=xx
Bypass code XX has been used
* Bypass Trbl C=xx
System troubles were bypassed by user XX
* Bypass Zone=xx
Zone no. XX is bypassed
Cancel Alarm P=x
Cancel alarm event has occurred from partition X. A valid user
function is entered to reset the alarm after the defined Abort alarm
time.
Change code=xx
Changing user code XX
Change FM=yy
Changing Follow-Me number YY
Change tag=xx
Changing keypad tag for user XX
Clock not set
Time is not set
Clock set C=xx
Time defined by user no. XX
Cloud Connected " ,
Cloud communication channel is functioning
Cloud Disconnect" , //
Cloud communication channel is not functioning
CO Alarm Zn=xx
CO alert from zone XX defined as a CO detector
CO Rst. Zn=xx
CO alert restored from zone XX defined as a CO detector
Com ok IP card
Communication OK between the WiComm Pro and IP card