Encrypted events are sent to the monitoring station over the IP or GPRS
network using TCP/IP protocol. 128 BIT AES encryption is used. RISCO
Group's IP/GSM Receiver Software located at the MS/ARC site receives
the messages and translates them to standard protocols used by the
monitoring station applications (For example; Contact ID).
Note: To enable GPRS communication the SIM card has to support GPRS channel
Reporting by IP can be established through different channels. Select
the required channel via the Configuration Software as follows:
• IP/GPRS: The panel checks for the availability of the IP network.
During regular operation mode all calls and data transmission are
carried out using the IP network line. In the case of trouble in the
IP network, the report is routed to the GPRS network.
• GPRS/IP: The panel checks for the availability of the GPRS
network. During regular operation mode all calls and data
transmission are carried out using the GPRS. In the case of trouble
the report is routed to the IP network.
• IP Only: The report is executed through the IP network only.
• GPRS Only: The report is executed through the GPRS network.
Enter the relevant IP and Port numbers for the MS that will receive
reports from the system.
Reports to the monitoring station can be transmitted using the SIA IP
protocol to standard SIA IP receivers. Using SIA IP enables
transmission of visual imagery from PIR cameras. Reporting by SIA IP
can be established through the hardware channels installed in your
system. Reporting of the SIA IP is 128 BIT AES encrypted. SIA IP
reports also support labels reporting. Usage of SIA IP requires setting:
⬧ Encryption Key (see page 96)
⬧ SIA IP Receiver Number
⬧ SIA IP Receiver Line Number
Note: In the IP Address field you can enter up to 64 characters (for
DNS Name of the monitoring software).
To Next Page
Loading...
