Communication: Monitoring Station
Specifies under what conditions an Alarm Restoral is reported. This option
informs the Monitoring Station of a change in the specified condition(s) during
an alarm restore. These reports need a valid Report Code.
⬧ On Bell Time Out (BTO) - Reports the restoral after the audible alarm times
out.
⬧ Follow Zone - Reports the restoral when the zone in which the alarm occurs
returns to its non-violated (secured) state
⬧ At Disarm - Reports the restoral when the system (or the partition in which
the alarm occurs) is disarmed, even if the siren has already timed out
A 32-digit digital signature and authentication for purposes of safeguarding
data transmission to and from the monitoring station. The key must be defined
for both the panel and monitoring station. For use when SIA IP report type is in
effect. A unique key can be defined for each of up to three monitoring stations
The receiver number as supplied from the monitoring station
The receiver line number as supplied from the monitoring station
Allows to program timers related to operation with the monitoring station.
The Periodic Test enables you to set the time period that the system will
automatically establish communication to the Monitoring Station in order to
check the connection. The periodic test involves sending the account number
and a valid test report code (Contact ID 602, SIA TX). Set the test time and daily
interval for Periodic Test Reporting.
Defines the time delay before reporting an alarm to the Monitoring Station. If the
alarm system is disarmed within the Abort Window, no alarm transmission
shall be sent to the MS.
To Next Page
Loading...
