The number that recognizes the customer at the monitoring station. You can
define an account number for each monitoring station. These account numbers
are the 6-digit numbers assigned by the Monitoring Station.
Notes for Account Number in Contact ID Communication Format:
• The account number will always be reported as 4 digits, for example: A number
defined as 000012 will be reported as 0012
• If more than 4 digits were defined, the system always sends the last 4 digits of the
account number, for example: Account number that was defined as 123456 will be
sent as 3456.
• In Contact ID you can place digits and letters A-F. The A character is always sent as 0
for example: Account number that was defined as 00C2AB will be sent as C20B.
Notes for Account Number in SIA Communication Format:
• Account number for SIA should be defined as a decimal number (Only digits 0..9)
• Account number can be reported as 1 to 6 digits. To send an account number with
less than 6 digits use the “0” digit, for example: For account number 1234 enter
001234. In this case the system will not send the “0” digit to the monitoring station.
• In order to send the “0” digit in SIA format, located at the left side of the number, use
the “A” digit instead of the “0” digit. For example, for account number 0407 enter
00A407, for a 6-digit account number such as 001207 enter AA1207.
Enables the system to contact the monitoring station in order to obtain details of
the communication protocol used by the digital receiver for each account.
The codes are automatically uploaded when the communication format has been
selected:
⬧ Contact ID: The system allocates Report Codes supporting ADEMCO
Contact (Point) ID
⬧ SIA: The system allocates Report Codes supporting the SIA (Security
Industry Association) format
Note: See Appendix A— Report Codes for the report codes list.
To Next Page
Loading...
