EasyManua.ls Logo

Risco RW332M - Page 132

Risco RW332M
157 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 126
L.Temp rst Zn=xx
Low temperature alert restored from zone XX defined as a
temperature detector
* Lost Zone=xx
Wireless zone lost, zone no. XX
Low Bat rs Z=xx
Low battery trouble restored from wireless zone no. XX
Low bat. Zn=xx
Low battery trouble from wireless zone no. XX
Low bat.KF=yy
Low battery trouble from wireless remote control XX
* Low Temp. Zn=xx
Low temperature alert from zone XX defined as a temperature
detector
Main:AC restore
AC power restore on main panel
Main: Battery rst
Low battery trouble restore from the main panel
Main: Low AC
Loss of AC power from the main panel
Main: Low battery
Low battery trouble from the main panel
* MS=y call error
Communication fail trouble to MS phone no. Y
* MS=y restore
Communication fail trouble restore to MS phone no. Y
No Com IP card
Communication failure between the WiComm Pro and IP card
* No comm I/O Mdl.
Communication failure between the WiComm Pro and I/O module
* No comm Siren=y
Communication failure between the WiComm Pro and siren Y
* No comm. GSM
No communication between the GSM/GPRS Module and the
WiComm Pro
* Phone fail
If the phone line is cut or the DC level is under 1V
Phone restore
Phone line trouble restore
* Police Keypad=y
Police (panic) alarm from wireless keypad Y
* Police KF=yy
Police (panic) alarm from remote control YY
PTM: Send Data
Load new parameters into the WiComm Pro from PTM accessory
* Radio l.bat S=y
Radio low battery trouble from siren Y
Radio l.bat rS=y
Radio low battery restore from siren Y
* Remote away:P=y
The system has been armed from the configuration software
* Remote program
The system has been programmed from the configuration software
* Remote stay:P=y
The system has been armed in STAY mode from the configuration
software
Restore Zone=xx
Alarm restore in zone no. XX
* RF Jamming
Wireless receiver jamming
Rmt disarm:P=y
Partition Y disarmed from the configuration software
* Siren=y Lost
Siren Y is regarded as lost following supervision test
Siren=y Lost Rst
The WiComm Pro received a signal from siren Y after it has been
regarded as lost
Soak fail Z=xx
Zone XX has failed in the soak test
Special KP=y
Special alarm from the from wireless keypad Y
Spkr l.bat rsS=y
Speaker low battery restore from siren Y
* Spkr low bat S=y
Speaker low battery trouble from siren Y
Start exit P=y
Exit time started in partition Y
* Stay:P=y C=zz
Partition Y Stay Armed (Partial Armed) by user ZZ

Table of Contents

Other manuals for Risco RW332M

Related product manuals