Risco RW332M - Setting WiComm Pro for EN 50131 Compliance

Page 145
Setting the WiComm Pro to Comply with EN 50131 Requirements
1. Access the installer Programming menu.
2. From the [1] System menu, select [5] to access the Settings menu.
3. From the Settings menu, select [4] to access the Standard option.
4. Select EN 50131; once selected, the following changes will occur in the WiComm Pro
software:
Report Codes Feature EN 50131 Compliance
Timers
Phone Line cut delay
Immediate (0 minutes)
Entry Delay
45 seconds (maximum allowed)
AC Delay
Immediate (0 minutes)
Jamming Time
0 minutes
RX Supervision
2 hours
System Controls
Quick Arm
Set to NO
False Code Trouble
Set to Yes
Forced Arming
Set to NO
Authorize installer
Set to YES
Override Trouble
Set to NO
Restore Alarm
Set to YES
Mandatory Event Log
Set to YES
Restore Trouble
Set to YES
Exit Alarm
Set to NO
20 Minutes Signal
Set to YES
Entry Alarm
Set to NO
Attenuation
Set to YES