Same as above, except that the Exit/Entry 2-time period applies.
Used for an Exit/Entry door. This zone behaves as described in the
Exit/Entry 1 parameter, shown above, except that, if faulted, the arming
process is not prevented. To avoid an intrusion alarm, it must be secured
before the expiration of the Exit Delay period.
Same as above, except that the Exit (Op)/Entry 2-time period applies.
Usually assigned to motion detectors and to interior doors protecting the
area between the entry door and the system.
These zone(s) causes an immediate intrusion alarm when violated unless an
Exit/Entry zone was violated first. In this case, Entry Follower zone(s) will
remain bypassed until the end of the Entry Delay period.
Usually intended for non-exit/entry doors, window protection, shock
detection, and motion detectors.
Causes an immediate intrusion alarm if violated after the system is armed or
during the Exit Delay period.
When Auto Arm and Pre-Warning are defined, the instant zone will be
armed at the end of the Pre-Warning period.
Used for Exit/Entry doors, as follows:
⬧ If the system is armed in the Away (Full Arm) mode, the zone(s)
provide a delay (specified by Exit/Entry 1) allowing entry into and exit
from an armed premises
⬧ If the system is armed in the Stay mode (Partial Arm), the zone is
bypassed
Same as the Interior + Exit/Entry 1 parameter, described above, but the
Exit/Entry 2-time period is applicable.
To Next Page
Loading...
