Rodgers PR-300 - Adding an Organ Part

(5) Press TRACK 3.
This specifies the track to
be merged to.
(6)
Press [ENTER].
The PR-300 will take the information removed
from Track 4 and merge
it with information on
Track 3.
o 0 0 0 0
...... ~ ..
TRANSPOSE
iJ\:::::!:~:!I::1
I~· I!
Now that the infonnation previously on Track 4 is
merged with infonnation on Track 3, it's possible to
sequence the flute descant.
Go ahead and sequence the descant found at right,
using steps
1) through 15) on pages 53-55. Use the
Flute voice on MIDI Channel 5 (Part 5) and sequence
it on Track 4. When finished, the sequence should
be
set up as follows:
Part 1 Soprano Track 1 Trumpet
Part
2 Alto Track 2 French Horn
Part 3
Tenor Track 3 Clarinet
Part
4 Bass Track 3
Cello
Part 5
Descant Track
4
Flute
Adding an Organ Part
Part 5 Channel 5 Track 5 Flute
Currently, the Multi-Track sequence you recorded
uses five different PR-300 sounds. It is possible to
add the resources
of your Rodgers PDJTM organ to a
sequence.
As stated above, the organ part must
be added last
(to an otherwise complete MIDI sequence).
In order for the organ to be recorded, all of the
Master Channels must
be activated and the PR-300's
master clock must
be enabled (we disabled the organ's
Great and Pedal Master Channels and PR-300's
master clock before recording the five PR-300
instrument parts).
55
Part 1 (PR-300 Instrument on channel 1)
Part 2 (PR-300 Instrument on channel 2)
Part 3 (PR-300 Instrument on channel 3)
Part 4 (PR-300 Instrument on channel 4)
Part 5 (PR-300 Instrument on channel 5)
To this we can add . ..
Organ Part (Rodgers organ on channels 11-16)