Rodgers PR-300 - Adding an Organ Part

I'· e
Go ahead and sequence the descant found at right,
using steps 1) through 15) on pages 61-64. Use the
Flute voice on MIDI Channel 5 (Part 5) and sequence
it on Track 4.
When finished, the sequence should be
set up as follows:
Part
1
Soprano
Track
1 Trumpet
Part 2 Alto
Track 2
French Horn
Part 3 Tenor
Track 3 Clarinet
Part 4
Bass
Track 3 Cello
PartS
Descant
Track
4 Flute
Adding an Organ Part
Part 5
ChannelS Track S
Flute
Currently, the Multi-Track sequence you recorded
uses five different PR-300 sounds.
It is possible to
add the resources
of your Rodgers LTG organ to a
sequence.
As stated above, the organ part must be added last,
to an otherwise complete MIDI sequence.
In
order for the organ to be recorded, the MIDI
Master Channels must be activated and the PR-3()()'s
master clock must be enabled (we suppressed the
organ's MIDI Master Channels and PR-300's master
clock before recording the five
PR-300 instrument
parts).
To
prepare the organ and PR-300 to record the
organ part:
(1) Enable the organ's MIDI Master Channels.
This is found under the "MIDI Master Channels"
section
of the organ's MIDI Phase II User's Guide.
If the MIDI Master Channels are not re-enabled,
the organ part will not be recorded.
(2) Press [MIDI] on the PR·300.
This button is located under the top cover. The
screen at right will appear in the display.
67
Part 1 (PR-300 Instrument on channel 1)
Part 2 (PR-300 Instrument on channel 2)
Part 3 (PR-300 Instrument on channel 3)
Part 4 (PR-300 Instrument on channel
4)
Part S (PR-300 Instrument on channel 5)
To this we can add . ..
Organ Part (Rodgers organ on channels 11-16)
Turn On Organ's
Master Channels
MIDI
-
DISK