Common Measurement Settings
R&S
®
FSW
344User Manual 1173.9411.02 ─ 19
For an overview of which generators support TTL synchronization see "Overview of
Generators Supported by the R&S FSW-B10 Option" on page 334.
Remote command:
SYSTem:COMMunicate:RDEVice:GENerator:LINK on page 888
GPIB Address / TCP/IP Address
For LAN connections: TCP/IP address of the signal generator
For GPIB connections: GPIB address of the signal generator.
Remote command:
SYSTem:COMMunicate:GPIB:RDEVice:GENerator:ADDRess on page 887
SYSTem:COMMunicate:TCPip:RDEVice:GENerator:ADDRess on page 888
Reference
Selects the internal R&S FSW or an external frequency reference to synchronize the
R&S FSW with the generator (default: internal).
Remote command:
SOURce:EXTernal:ROSCillator[:SOURce] on page 887
Edit Generator Setup File
Displays the setup file for the currently selected Generator Type in read-only mode in
an editor.
Although the existing setup files are displayed in read-only mode in the editor, they can
be saved under a different name (using "File > SaveAs").
Be careful, however, to adhere to the required syntax and commands. Errors will only
be detected and displayed when you try to use the new generator (see also "Displayed
Information and Errors" on page 341).
For details see "Generator Setup Files" on page 335.
Frequency Min. / Frequency Max.
For reference only: Lower and upper frequency limit for the generator.
Level Min. / Level Max.
For reference only: Lower and upper power limit for the generator.
Measurement Settings
The measurement settings for external generator control are configured in the "Mea-
surement Configuration" subtab of the "External Generator" tab.
Data Input and Output
To Next Page
Loading...
