Remote Commands
R&S
®
FSW
761User Manual 1173.9411.02 ─ 19
Usage: Event
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:MARGin <Threshold>
This command defines the threshold of the list evaluation.
Parameters:
<Margin> Range: -200 to 200
*RST: 200
Default unit: dB
Example:
CALC:ESP:PSE:MARG 100
Sets the margin to 100 dB.
Manual operation: See "Margin" on page 225
See "Margin" on page 247
CALCulate<n>:ESPectrum:PSEarch|PEAKsearch:PSHow
This command turns the peak labels in the diagram on and off.
Peak labels are blue squares.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:ESP:PSE:PSH ON
Marks all peaks with blue squares.
Manual operation: See "Show Peaks" on page 225
See "Show Peaks" on page 247
11.5.6.9 Performing an SEM Measurement
The following commands are required to perform an SEM measurement:
SENS:SWE:MODE ESP, see [SENSe:]SWEep:MODE on page 731
INITiate[:IMMediate] on page 694, see chapter 11.5.1, "Performing Measure-
ments", on page 692
11.5.6.10 Retrieving Results
The following commands analyze and retrieve measurement results for SEM measure-
ments.
● CALCulate:LIMit<k>:FAIL? on page 987
● CALCulate:MARKer:FUNCtion:POWer<sb>:RESult? on page 696
● TRACe<n>[:DATA] on page 922
● TRACe<n>[:DATA]:MEMory? on page 924
Configuring and Performing Measurements
To Next Page
Loading...
