Remote Commands
R&S
®
FSW
911User Manual 1173.9411.02 ─ 19
Note that the command has no effect if critical parameters like the span have been
changed to avoid invalid measurement results
Parameters:
<State> ON
The automatic reset is off.
OFF
The automatic reset is on.
*RST: OFF
Example:
DISP:WIND:TRAC3:MODE:HCON ON
Switches off the reset function.
Manual operation: See "Hold" on page 466
DISPlay[:WINDow<n>]:TRACe<t>[:STATe] <State>
This command turns a trace on and off.
The measurement continues in the background.
Parameters:
<State> ON | OFF | 0 | 1
*RST: 1 for TRACe1, 0 for TRACe 2 to 6
Example:
DISP:TRAC3 ON
Usage: SCPI confirmed
Manual operation: See "Trace 1/Trace 2/Trace 3/Trace 4 (Softkeys)" on page 468
[SENSe:]AVERage:COUNt <AverageCount>
This command defines the number of sweeps that the application uses to average
traces.
In case of continuous sweeps, the application calculates the moving average over the
average count.
In case of single sweep measurements, the application stops the measurement and
calculates the average after the average count has been reached.
Parameters:
<AverageCount> If you set a average count of 0 or 1, the application performs one
single sweep in single sweep mode.
In continuous sweep mode, if the average count is set to 0, a
moving average over 10 sweeps is performed.
Range: 0 to 200000
*RST: 0
Usage: SCPI confirmed
Manual operation: See "Sweep/Average Count" on page 412
See "Average Count" on page 467
Analyzing Measurements (Basics)
To Next Page
Loading...
