Remote Commands
R&S
®
FSW
935User Manual 1173.9411.02 ─ 19
CALCulate:MARKer:X:SLIMits[:STATe] <State>
This command turns marker search limits on and off.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Parameters:
<State> ON | OFF
*RST: OFF
Example:
CALC:MARK:X:SLIM ON
Switches on search limitation.
Manual operation: See "Search Limits (Left / Right)" on page 192
See "Deactivating All Search Limits" on page 192
See "Limit State" on page 267
CALCulate:MARKer:X:SLIMits:LEFT <SearchLimit>
This command defines the left limit of the marker search range.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Parameters:
<SearchLimit> The value range depends on the frequency range or sweep
time.
The unit is Hz for frequency domain measurements and s for
time domain measurements.
*RST: left diagram border
Example:
CALC:MARK:X:SLIM ON
Switches the search limit function on.
CALC:MARK:X:SLIM:LEFT 10MHz
Sets the left limit of the search range to 10 MHz.
Manual operation: See "Search Limits (Left / Right)" on page 192
See "Left Limit / Right Limit" on page 268
CALCulate:MARKer:X:SLIMits:RIGHT <SearchLimit>
This command defines the right limit of the marker search range.
If you perform a measurement in the time domain, this command limits the range of the
trace to be analyzed.
Parameters:
<Limit> The value range depends on the frequency range or sweep
time.
The unit is Hz for frequency domain measurements and s for
time domain measurements.
*RST: right diagram border
Analyzing Measurements (Basics)
To Next Page
Loading...
