Rohde & Schwarz SMW-K144 - Page 187

Remote-Control Commands
R&S
®
SMW-K144
187User Manual 1178.8013.02 ─ 06
Parameters:
<SCSpacing> N15 | N30 | N60 | N240 | N120
*RST: N30
Example: See Example "Configuring the users and the BWPs"
on page 151.
Manual operation: See "SC Spacing/CP" on page 54
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
RBNumber <UlBwpRBNumber>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
RBNumber <DlBwpRBNum>
Sets the number of resource blocks (RB) the bandwidth part (BWP) occupies.
Parameters:
<DlBwpRBNum> integer
Range: 11 to 273
*RST: 11
Example: See Example "Configuring the users and the BWPs"
on page 151.
Manual operation: See "No. RBs" on page 54
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
RBOFfset <RBOffset>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
RBOFfset <RBOffset>
Sets the offset between the first resource block in the BWP relative to the first usable
resource blocks (URB).
Parameters:
<RBOffset> integer
Range: 0 to 255
*RST: 0
Example: See Example "Configuring the users and the BWPs"
on page 151.
Manual operation: See "RB Offset in TxBW" on page 55
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PRBoffset?
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:DL:BWP<dir0>:
PRBoffset?
Queries the frequency starting position of the BWP relative to the point A.
DL/UL BWP Commands