Rohde & Schwarz SMW-K144 - Page 207

Remote-Control Commands
R&S
®
SMW-K144
207User Manual 1178.8013.02 ─ 06
Parameters:
<TypeAConfigType> T1 | T2
*RST: T1
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Config Type" on page 75
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTB:MLENgth <TypeBMaxLength>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTA:MLENgth <TypeAMaxLength>
Sets if single- or double-symbol DMRS is used.
Parameters:
<TypeAMaxLength> integer
Range: 1 to 2
*RST: 2
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Max Length" on page 76
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTB:APINdex <TypeBAddPosIdx>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTA:APINdex <TypeAAddPosIdx>
Sets the additional possition index.
Parameters:
<TypeAAddPosIdx> integer
Range: 0 to 3
*RST: 0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Additional Position Index" on page 76
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTA:SID0 <ScramID0>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTA:SID1 <ScramID1>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTB:SID0 <ScramID0>
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:
PUSCh:DMTB:SID1 <ScramID1>
Sets the scrambling ID.
BWP Configuration Commands