Rohde & Schwarz SMW-K144 - Page 224

Remote-Control Commands
R&S
®
SMW-K144
224User Manual 1178.8013.02 ─ 06
Parameters:
<CDMGroupData> integer
Range: 0 to 2
*RST: 1
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "CDM Groups w/o Data" on page 90
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PDSCh:APSelect<s2us0> <PdschAPSel>
Queries the antenna ports.
Suffix:
<s2us0>
.
0 to (Number of layers - 1)
Antenna port
Parameters:
<PdschAPSel> AP1000 | AP1001 | AP1002 | AP1003 | AP1004 | AP1005 |
AP1006 | AP1007
*RST: AP1000
Example: See Example "Configuring the PDSCH incl. PTRS settings"
on page 153.
Manual operation: See "Antenna Ports" on page 98
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:APSelect<s2us0> <PuschAPSel>
Queries the antenna ports.
Parameters:
<PuschAPSel> AP0 | AP1 | AP2 | AP3 | AP4 | AP5 | AP6 | AP7
*RST: AP0
Example: See Example "Configuring the PUSCH settings" on page 159.
Manual operation: See "Antenna Ports" on page 98
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:PUSCh:TXSCheme:TPMidx <TxTPMIIndex>
For PUSCH DCI format 0_1, sets the TPMI index, required to select the precoding
matrix.
Parameters:
<TxTPMIIndex> integer
Range: 0 to 27
*RST: 0
PDSCH/PUSCH Commands