5G New Radio Configuration and Settings
R&S
®
SMW-K144
74User Manual 1178.8013.02 ─ 06
Test condition Fre-
quency
Subset Modula-
tion
Reference channels
Fixed Reference Channels for performance
requirements
FR1 A3 QPSK G-FR1-A3-1 to G-
FR1-A3-32
A4 16QAM G-FR1-A4-1 to G-
FR1-A4-28
A5 64QAM G-FR1-A5-1 to G-
FR1-A5-14
FR2 A3 QPSK G-FR2-A3-1 to G-
FR2-A3-12
A4 16QAM G-FR1-A4-1 to G-
FR1-A4-10
A5 64QAM G-FR1-A5-1 to G-
FR1-A5-5
"TS 38.141: G-FR1"
Subset of FRCs defined for the FR1 (≤ 6 GHz).
"TS 38.141: G-FR2"
Subset of FRCs defined for the FR2 (> 6 GHz)
"Not Available"
Indicates that there is no FRC defined for the current combination of
"SC Spacing/CP" and "No. RB".
If FRC is selected, the following parameters are set automatically:
●
DMRS for Mapping Type A parameters Config Type, Additional Position Index and
Max Length.
●
PUSCH allocations
●
All FRC parameters in the "FRC" dialog.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:FRC:
TYPE on page 203
Subcarrier Spacing ← FRC settings
Indicates the SCS of the selected FRC. It is the same as the SCS of the selected BWP.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:FRC:
SCS? on page 204
Allocated Resource Blocks ← FRC settings
Indicates the number of used RBs of the selected FRC.
Remote command:
[:SOURce<hw>]:BB:NR5G:UBWP:USER<ch0>:CELL<st0>:UL:BWP<dir0>:FRC:
ALRB? on page 204
Modulation ← FRC settings
Indicates the modulation scheme used by the selected FRC.
Users/BWPs Settings
To Next Page
Loading...