Rohde & Schwarz SMW-K144 - Page 82

5G New Radio Configuration and Settings
R&S
®
SMW-K144
82User Manual 1178.8013.02 ─ 06
Once configured, these allocations are repeated as defined in the Repetition field.
●
Read-only allocations
These allocations are configured automatically, based on: scheduling mode, DCI,
repetition of an allocation configured in previous or same subframe, ongoing allo-
cations, aggregated PDSCH, or because they are configured elsewhere, like for
example SS/PBCH, SRS, CSI-RS, dummy RE.
You can observe the allocations in all available subframes, where the number of
subframes depends on the ARB sequence length.
Settings:
Cell................................................................................................................................82
Subframe.......................................................................................................................82
Next/Prev...................................................................................................................... 82
Expand/Collapse...........................................................................................................83
Content..........................................................................................................................83
No. of Allocations.......................................................................................................... 83
SC Spacing/CP............................................................................................................. 83
Slot................................................................................................................................83
Mapping Type................................................................................................................84
Format...........................................................................................................................84
Slot Format....................................................................................................................84
No. Sym........................................................................................................................ 84
Sym. Offset....................................................................................................................85
No. RB...........................................................................................................................85
Offs. RB.........................................................................................................................85
Transform Precoding.....................................................................................................85
Settings......................................................................................................................... 85
Power............................................................................................................................86
State..............................................................................................................................86
Repetition......................................................................................................................86
Cell
Selects/indicates to which carrier/cell the settings apply.
Remote command:
via suffix at CELL<ch>
Subframe
Sets the subframe to be configured.
The maximum number of available subframes N
SF
is calculated as follows:
N
SF
= 10 * "ARB Sequence Length" - 1
Remote command:
via suffix at SUBF<st0>
Next/Prev
Navigates through the subframes.
Remote command:
n.a.
Scheduling Settings