Rohde & Schwarz SMW-K144 - Page 84

5G New Radio Configuration and Settings
R&S
®
SMW-K144
84User Manual 1178.8013.02 ─ 06
Slot SCS / CP
0 to 7 120 kHz NCP
0 to 15 240 kHz NCP
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:SLOT on page 214
Mapping Type
Defines to which symbols of the PDSCH/PUSCH allocation the demodulation refer-
ence signals (DMRS) are mapped.
"A"
Location relative to the start of the slot.
"B"
Location relative to the start of the PDSCH resources.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:MAPType on page 215
Format
In uplink, selects the PUCCH format.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:FMT on page 215
Slot Format
Indicates the slot format, see "Frame structure" on page 14.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:SLTFmt? on page 215
No. Sym.
Indicates the time duration of the allocation inside the slot.
The available values depend on the CP and the Mapping Type, see Table 5-2.
Table 5-2: No. Sym. (L)
Mapping Type Normal Cyclic Prefix Extended Cyclic Prefix
Mapping Type A 3, 14 3, 12
Mapping Type B 2, 4, 7 2, 4, 6
The parameters "No. Sym." and "Sym. Offset" are interdepended; their sum must not
exceed the maximum of 14 or 12 symbols, for normal and extended CP respectively.
Remote command:
[:SOURce<hw>]:BB:NR5G:SCHed:CELL<ch0>:SUBF<st0>:USER<dir0>:
BWPart<gr0>:ALLoc<user0>:SYMNumber on page 216
Scheduling Settings