An Error Message Appears
7
FAQ
183
Operation cannot be continued. Switch o the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (20 to 30°C) and allow the machine to come to room temperature, then turn on the power.
[SERVICE CALL xxxx]
An unrecoverable error occurred, or part replacement that must be performed by a service
technician is required.
Note the number displayed, then switch o the sub power. After you switch o the power, inform your autho-
rized Roland DG Corp. dealer of the number that appeared on the display screen.
[SHEET TOO SMALL CONTINUE?]
The size of the data is larger than the printing or cutting area of the loaded media.
To continue performing output without correcting this, press . At this time, the portion extending
beyond the printing or cutting area is not output. To stop output, stop sending data from the computer, then
hold down
for one second or longer. Make the printing or cutting area wider, such as by replacing
the media with a larger piece of media or by changing the positions of the pinch rollers, then send the data
again.
[SHEET SET ERROR SET AGAIN]
was pressed even though no media is loaded.
Press any key to clear the error. Load media and pull back the loading lever, then press .
P. 36, "Loading Media"
[EDGE DETECTION] is set to "ENABLE," but transparent media was loaded.
Flip the loading lever down to the rear, set the [EDGE DETECTION] menu item to "DISABLE," then reload the
media.
P. 129, "Using Transparent Media"
The loaded media is too small.
Press any key to clear the error. Replace with media of usable size.
[TEMPERATURE IS TOO LOW **°C]
The temperature of the location where the machine is installed has fallen below the ambient
temperature at which the machine can operate.
Operation cannot be continued. Switch o the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation is
possible (20 to 30°C) and allow the machine to come to room temperature, then turn on the power.
[DATA ERROR CANCELING...]
Output was stopped because a problem was found in the data received.
Operation cannot be continued. Check whether the data contains errors. Also, check for a problem with the
connector cable or the computer, and redo the operation from the step of loading the media.
[PINCHROLL ERROR LOWER PINCHROLL]
was pressed without rst lowering the pinch rollers.
Pull back the loading lever, then press .
The pinch rollers are lifted up during output.
Output is discontinued. Do not move the loading lever during output.
To Next Page
Loading...
Need help?
General