2
Basic
Operation
Setup of Media
64
Check the correction values from the test pattern condition.
Use to set the correction value of feed
direction (F).
Use
to set the correction value of scan
direction (S).
Press
to enable the setting.
The test pattern (C&C1) is printed and cut again. Check the condition
of test pattern to check that the printing position and the cutting
position are aligned.
[Cutting position and printing position are aligned]
Press
to select [DONE].
Press
to enable the setting.
Go to Procedure
9
.
[Cutting position and printing position are not aligned]
Press
to select [YES].
Press
to enable the setting.
Go back to Procedure
and set the correction values again. And
repeat Procedure
and
until the optimal alignment is got.
For the individual setting method of this setting item and the description, refer to page 149 "Correcting Mis-
alignment for Printing and Cutting When Using Crop Marks."
To check the test pattern (C&C2)
The point where the cutting line intersects the correction-value scale is the correction value. Check
the scan direction and the feed direction respectively.
F :- 0.30 - 0.30mm
S : 0.00 - 0.20mm
REDO ADJ. ?
YES [DONE]
Feed direction
Correction
value scale
Scan direction
Cutting line
Cutting line
For the gure, the cor-
rection value is “-0.3.”
Current correction
value
Value to be set
To Next Page
Loading...
